WOOD FLOOR GLUE

wood floor glue:solvent-free ,one part polyurethane modified adhesive, water resistance and weather resistant

   PRODUCT flooring adhesive GU303

Description

      GU303 is an adhesive and sealand for carpentry application.GU303 is suitable to adhere most types of wood,parquet and sheet timber flooring  with concrete, tile or mosaic. The flooring is may applied in gymnasium, school, family, etc or bus, boats, various traffic tools

 Characteristics

1. GU303 is a solvent-free ,one part polyurethane modified adhesive ,with very friendly  to the environment and human health.

2.  easy to operate With the high-efficiency

3.  Has good adhesion to wood or concrete.

4. GU303  has good water resistance and weather resistance, can be used indoor or outdoor

5. good chemical resistance and heat resistance . Can be used in Flooring heating system

6. outstanding elasticity, and provides assistance to increase  sound-absorbing function for the flooring and increased comfort level to walk

7.It is very convenient to move the adhesive for repairing flooring because of appropriate cohesion of the glue.

 Properties

	GU303
Component	Modified polyurethane
Appearance	White paste
Viscosity (cps brookfield25°C)	10,000~100,000
Density	1.8±0.2
Thickness	400~600g/mm
Pot time	About 30min	At 25°C
Curing time	24hour or more	At 25°C
heat resistance	Used blow 60 °C
Sheer N/cm2(wood/concrete)	>100	After 1 week at At  25°C

Instrument of operation:A2 or A3 drawknife

Directions for use

1. The subfloor most be dry, level, smooth, structurally sound and free from grease, dirt, dust, paint

2.  It is important that the proper operation temperature is 10°C~30°C.The viscosity of GU303 will be too high at low temperature, and the operation time will be increased too much. At  high temperature  the pot time of GU303 will be too short to affect operation.

3. To dispense, cut off the foil at the angle of the package with a knife or scissors. Pointing the open end towards the floor, squeeze the package from the top to the bottom until the content is completely extruded.

4. By a single coat of v-notched trowel uniformly, combing the glue with enough pressure to achieve good contact to the substrate. Set the wood or other materials then put pressure to full contact on each individual board.

5. Waiting for the curing of glue about minimum 24hour.

Remarks

1. If the material gets in the eyes, immediately wash the eyes with copious amounts of water occasionally lifting the lower and upper eyelids. Continue for 15 minutes. Get medical attention immediately. If the material gets on the skin, immediately wash the area with soap and water and flush with water. If the material gets on clothing, remove the clothing and wash the affected area with soap and water .If irritation develops, get medical attention. Discard or wash contaminated clothing before reuse.

2. Avoid unnecessary movement of tiles during curing condition

3. User is recommended to test the performance of adhesion before paving tiles

WOOD FLOOR GLUE